The rear shocks of my 1982 GoldWing Standard had given up the
ghost! Taking a speed bump at anything greater than a walk would
cause the rear suspension to bottom out no matter how much air
was in the shock. The shocks held air, but they no longer had any
I first intended to replace the shocks or rebuild them. I looked at Progressive Suspension replacements at over $300, then at their rebuild kits for $150. An attempt at buying the rebuild kit had them backordered without any known delivery date. I thought about non-air alternatives, but felt that it would be a step backward to remove that functionality from the bike.
Finally, I checked out my shop manual, and while the Clymer manual say they are not rebuildable, the Honda shop manual gives instructions for replacing the seals and refilling with oil - just like the front forks!
Checking the exploded views at Bikebandit pointed me toward ordering a pair of seals for the units. They arrived in just a couple of days.
My camera fooled me and didn't take all the pictures I pointed it at - so I'll try to explain what the camera missed.
I've got a standard, so all I had to deal with is my aftermarket Samsonite bag hardware.
Ready to pull the shocks. Notice the yellow stain on the differential? I thought that it was a leak at the drive shaft joint while it was actually a stain from the shock oil leaking on it. The Honda manual describes removing all the air line plumbing back to the filler. What I did was loosen the fitting while the shock was still on the bike then just turn the shock off of the air fitting after pulling the shock off the bike.
My local independent shop suggests using only Honda seals. The pair were just under $30 including delivery from Bikebandit.
This is really a photo from my fork rebuild page, but the technique is exactly the same. Remove the circlip and washer (I modified a big circlip plier from Harbor Freight). Removal of the seals needs air pressure and the Honda manual says to add a tire valve to the air hose inlet and pressurize them that way. I just used a rubber tipped blow gun. Honda says to put the boot back on the shock, hold it upside down in a vise and wrap it with rags while blowing. That's a good idea because it will make a BIG mess even when you do that.
My shock on the drive side barely had any oil left in it. The left side had maybe half of its oil. Holding the shock upside down will allow some to drain out the air fitting hole after pumping it some.
With the air line hole plugged (I used a short length of fuel line and a screw) you hold the shock upside down in a vise and refill with 12.5oz of oil. The Honda manual suggests ATF, but I used 15 wt fork oil, since that is what my local shop had suggested for my front forks. Look at how much oil that is compared to what came out!
I used a length of 1-1/2" PVC tube to drive the new seal back into the shock. It worked as a wonderful slide-hammer, and I didn't have to worry about scratching anything with metal. (This is really a shot from my fork rebuild)
Bike's back together and rolling now! I ran right over to my favorite patch of speed bumps and the shocks WORK again. From walking out into the shop until the first shock was rebuilt and remounted took 1.5 hours. The second shock only took .5 hour total. I was back inside and washing my hands in 2.5 hours, and it would probably only be 2 hour job now that I've done it once. Seals and oil was less than $35. Maybe I won't wait 20 years before I do it again!
The '83 and later shocks have heavier springs, so I don't know how
that would effect the shock disassembly. Let me know and I'll add
That's all I know. If there's something that should be added, tell me: email@example.com
Back to my GoldWing page